Style: Dress uniform shirt, seven (7) button placket front, banded collar, placket front, two (2) patch pockets, rounded flaps with hook & loop or button closure, pencil opening in left flap, epaulets, long sleeve.
Fabric: Contents: Contents: 65% Dacron® polyester, 35% cotton Construction: Warp = 106, Filling = 50
Yarns: 26 singles Weave: Poplin
Weight: 7.1 ozs./lin.yd.
4.25 ozs/sq. yd.
Dying: High pressure jet dyed Finish: Soil release
Front: There shall be a full separate placket on the left front, 1 ½” wide, sewn on, having one buttonhole on the collar stand and buttonholes on the front spaced 3 ½” apart. The right front shall be plain with a minimum turned back facing of 1
¼”. There shall be no raw edge on this facing. 19 ligne buttons shall be attached to the right with corresponding buttonholes on the placket. There shall be an extra button at the bottom of the right front
Pockets: There shall be two (2) patch pockets. They shall be 5 ½” wide with mitered corners and 6 ½” high (finished with flap). The flap shall be 5 ½” wide, rounded type. The flap shall finish clean underneath. The sides shall be 2 ½” high and the center shall be 2 ¾” high. There shall be a 1” wide pencil opening in the left flap to correspond with the sewn in pencil compartment in the left pocket. Top stitching shall be 1/32” on all sides of the pockets and flaps with a double needle stitch spaced ¼” at the top of the flaps. There shall be a stitched buttonhole and 19 ligne buttons, both on the flap. The flaps shall close with a hook and loop or button closure. This shall identically match the color of the shirt.
Collar: There shall be a banded collar. The points shall be 3 ¼” long. There shall be permanent collar stays. The interlining shall be woven polyester or canvas. The collar shall be topstitched ¼” from the edge and shall close with a 19 ligne button.
Sleeves: Sleeves shall be common length with sewn hem and no rough edges showing
Yoke and Back: There shall be a two
(2) piece yoke, stitched and turned. Yoke shall be 3 ¼” below the collar seam in back.
Epaulets: There shall be two (2) “X” stitched epaulets made of two plies of self-material with a button closure. These shall be interlined with woven polyester or canvas material. The pointed end shall finish ½” from the neck seam. They shall measure 1 ¾” wide at the shoulder seam and taper to 1 ½” by the button, and then come to a point.